Cwfl-6000 Manual |verified|

Place the unit on a flat, level surface capable of bearing its full operating weight. Provide a minimum clearance of to nearby obstacles and 50 cm from the rear exhaust fan outlet to allow unrestricted heat dissipation. 2. Fluid Reservoir Preparation

Snap them back into place. Never run the chiller permanently without these filters. Every 3 Months: Change the Water Turn off the chiller and laser system.

Routine maintenance prevents catastrophic downtime and protects your multi-thousand-dollar laser investment. Weekly Maintenance cwfl-6000 manual

Water temperature has dropped below safe limits (common during cold morning startups). Wait for the internal heater to warm the water.

: A decoding table for system errors such as: E1 : Ultra-high room temperature. E2 : Ultra-high water temperature. E5/E6 : Water flow alarms. Why the Manual is Critical Place the unit on a flat, level surface

Tap water, well water, and mineral water. These introduce scale buildup that restricts heat transfer. Filling the Reservoir

Connect the "Inlet" of the chiller to the "Outlet" of the laser cutting head/optics, and vice versa. Fluid Reservoir Preparation Snap them back into place

High-pressure flow for consistent thermal regulation. 📦 Installation Steps

The flow rate may be too low. The CWFL-6000 manual specifies minimum 25L/min for the L1 circuit. Measure with a flow meter. If low, check the Y-strainer (inside the water outlet)—it often clogs with algae or sediment.

Up to 15kW depending on ambient conditions. Temperature Stability: ±1°C. Refrigerant: Environmentally friendly R-410a.