Quectel Change Imei Install Work

AT+CGSN=1

Install the official Quectel LTE/5G Windows or Linux USB drivers to expose the virtual COM ports.

Set the baud rate to (default for most Quectel modules), with 8 data bits, no parity, and 1 stop bit.

We use our own and third-party cookies to improve your experience and our service. By continuing to browse, you agree to their use.

Modifying the IMEI on Quectel modules is a common but sensitive procedure primarily used for "IMEI repair" or to bypass carrier restrictions. While technically possible through specific or third-party tools like DC-Unlocker , it is officially discouraged by Quectel and is illegal in many jurisdictions. Performance & User Experience quectel change imei install

For the changes to take effect with the network operator, power cycle the device or send: AT+CFUN=1,1 Use code with caution. Troubleshooting and Technical Considerations

A high-quality data cable capable of handling power and high-speed data transfer.

This report outlines the technical procedures, software requirements, and regulatory implications for modifying the International Mobile Equipment Identity (IMEI) on Quectel modules. 📋 Executive Summary

Quectel’s proprietary and QFirehose tools, combined with specific AT commands, provide the ability to rewrite the IMEI. However, this is not a simple “one-click” process—it requires entering a special diagnostic mode and using vendor-specific commands. AT+CGSN=1 Install the official Quectel LTE/5G Windows or

Once approved, Quectel will provide the authorized firmware, proprietary tools (such as QNavigator), and specific AT command sequences to securely update the IMEI. Step 5: Reboot and Verification

Open the connection and type AT followed by Enter. The module should respond with OK . Primary Diagnostics Commands

If your module uses an alternative firmware structure or chipset, it might require a direct engineering configuration token: AT+IMEI="123456789012345" Use code with caution. Step 4: Verify the Command Execution

Reconnect to the and issue the identification query: AT+CGSN Use code with caution. By continuing to browse, you agree to their use

Attempting to change the IMEI on a Quectel module introduces severe operational risks:

The AT+NTSETID command (available on some Quectel modules) sets system identities such as UUID or IMEI value temporarily. This command only works when the radio is inactive ( AT+CFUN=0 ) and the changes are lost after a reboot. For a permanent change, you must use AT+EGMR or low‑level tools.

Verify the current state of the device using these standard commands: