Take note of the number listed in this profile (you will need this for your new router).
A power loss during an update can permanently damage the unit.
802.11b/g/n Wi-Fi operating on the 2.4GHz band with a 2x2 MIMO antenna configuration.
4 x 10/100/1000 Base-T Gigabit Ethernet ports (RJ-45). Voice Ports: 2 x POTS ports (RJ-11) for VoIP services. USB Ports: 2 x USB 2.0 host interfaces. Wi-Fi Standard: 802.11b/g/n (2.4 GHz frequency band only). MIMO Support: 2x2 MIMO with internal antennas. firmware modem alcatel lucent i-240w-a
If you prefer using a high-performance secondary Wi-Fi router (e.g., an ASUS, Netgear, or TP-Link Mesh system) alongside the I-240W-A, configure the ONT to act strictly as a transparent modem. Navigate to . Select your primary internet connection profile. Change the Connection Mode from Route to Bridge .
Firmware deployment on the I-240W-A occurs through two primary methodologies: ISP-managed automated provisioning or manual local upgrading. Method A: Automated Remote Upgrades (TR-069 Protocol)
Ensuring stable communication with your Service Provider's OLT. Take note of the number listed in this
Class B+ optical receiver with an SC/APC connector. LAN Ports: 4 Gigabit Ethernet (10/100/1000 Base-T) ports. POTS Ports: 2 RJ-11 analog telephone ports for VoIP. Wi-Fi Standard: 802.11b/g/n (2.4 GHz band only).
Before attempting any modification or diagnostic review, you must establish a secure connection to the device's operating system environment. Step 1: Physical Connection
(Note: Some ISP-specific firmware versions alter this baseline to 192.168.0.1 or 192.168.100.1 ). Step 3: Authentication 4 x 10/100/1000 Base-T Gigabit Ethernet ports (RJ-45)
Most ISPs will remotely update your modem within 24 hours rather than give you the file.
: Uses U-Boot for the initial startup and firmware loading process. Management & Updates
is the permanent software programmed into the read-only memory (ROM) of the Alcatel Lucent I-240W-A. It is the operating system of your modem. It controls: