Manual Exclusive | Ts1162 Installation

Below is a guide for the installation and initial setup based on the Santa Fe Advance100 Installation & Operation Instructions .

: Press the local RTE button to confirm the open-collector output fires and fires the door relay cleanly. 🔒 Manufacturer & Security Guidelines

: Rated IP67 for superior weather and dust resistance.

: Features a dedicated Request to Exit (RTE) input and an open collector output for controlling door relays or strikes. ts1162 installation manual exclusive

Connect a Category 6e (or higher) shielded twisted-pair cable to the RJ-45 Ethernet management port. This interface isolates drive telemetry and SNMP traps from the primary data path. 5. Firmware Initialization and Configuration

Attach the left and right outer slide rails to the 19-inch rack frame, securing them with M6 retention screws.

Before diving into the installation process, it's essential to verify that all necessary components are included in the package: Below is a guide for the installation and

Each device on the Challenger RS-485 LAN requires a unique address so the main panel knows which keypad is performing which action. Enter the installer menu using your installer code. Navigate to .

The TS1162’s sensitive Hall-effect sensors are vulnerable to ground loops. The standard manual shows a basic earth connection; this exclusive manual provides a .

If you need the RTE switch to trigger a buzzer, unlock the door, or log an event in the system: Navigate to in your programming menu. : Features a dedicated Request to Exit (RTE)

After completing the installation, verify that:

Ensure the permanent error log remains clean ( 0x0000 status codes) and check that the read/write channels don't show sudden signal drops.