Manual: Orbitor Prospector 100 Metal Detector

The needle swings from left (Ferrous/Iron) to right (Silver/Copper). The colored zones are:

Lower the Discrimination setting to search for broader metal types. 7. Safety and Maintenance Precautions

Replace with a brand-new 9V alkaline battery. Check the +/- orientation. Orbitor Prospector 100 Metal Detector Manual

Snap the 9-volt battery onto the terminal clips. Ensure correct polarity (+/-). Slide the cover back into place until it clicks. 3. Control Panel and Settings

| Category | Key Features | |----------|---------------| | Modes | All-metal, Discrimination, Prospecting (Gold), Beach/Salt, Pinpoint | | Target ID | 12-segment, 0–99 numeric, ferrous bar, 3 tones | | Ground Balance | Manual, Auto (one-touch), mineralization indicator | | Coil | 10″×7″ DD waterproof (standard), 6″ DD optional | | Audio | Speaker, 3.5mm jack, vibration mode | | Display | Backlit LCD with depth, battery, sensitivity, notch pattern | | Battery | 2×9V (~25 hrs), low-battery warning | | Durability | IP54 control box, IP68 coil, telescoping aluminum shaft | | Special | Notch filter, iron mask, freq shift, depth calibration | The needle swings from left (Ferrous/Iron) to right

If you have lost your physical manual, follow these standard steps to get up and running: Detector Warehousehttps://detectorwarehouse.com How to Identify and Interpret Metal Detector Signals?

Follow these steps to tune your Orbitor Prospector 100 before every hunt. Safety and Maintenance Precautions Replace with a brand-new

Sweep the coil left-to-right over the target zone to find the loudest audio peak. Stop and turn your body 90 degrees. Sweep the coil forward-and-back across that same spot.

Walk slowly forward. Sweep the coil from side to side in a wide arc. Each sweep should overlap the previous one by 50% to ensure total ground coverage.

Distinguishes between ferrous (iron) and non-ferrous (precious) metals.