Are you replacing an or installing one in a new location ?
Drilling the top "keyhole" slot first allowed Alex to hang the unit and align it perfectly before drilling the bottom holes.
First, unpack your Galaxy Aqua Premier and ensure all components are present. You should typically have:
Before starting, ensure your site meets these technical requirements: Water Supply : Must be a mains cold water supply with a minimum running pressure of (15 psi) at a flow rate of 8-9 litres/minute. Electrical Rating : For the 9.5kW model, 10mm² wiring is recommended to handle the high current safely. Positioning galaxy aqua premier installation manual better
: Ensure the earth wire is securely connected and sleeved.
Alex carefully trimmed the plastic entry ports for the pipes and cables. Chapter 3: The Connection With the unit mounted, the real work began.
Do not drink the first few glasses of water. A proper system flush sanitizes the internal lines and primes the filters for daily operation. Are you replacing an or installing one in a new location
Slide the chrome escutcheon plate and rubber washer onto the faucet stem.
Position the unit away from direct spray and high enough so the handset cannot be immersed in used water. Use a 5.5mm masonry drill for fixing holes.
: Secure the front cover and reattach control knobs. Ensure knobs are correctly aligned with the internal spindles before fully tightening the cover screws. 5. Commissioning You should typically have: Before starting, ensure your
A: First, ensure the water supply valve is fully open. Check for kinks in the tubing. If you have a storage tank, ensure its valve is open. If the problem persists, you may have a clogged pre-filter or a malfunctioning pump. Contact customer support for assistance.
Locate the main Reverse Osmosis (RO) housing cap on the main unit.
Connect the tubing leading to the Drain Saddle.
: Built with a steel backplate for long-term durability.
Complete Installation Guide for the Galaxy Aqua Premier Water Purifier