Phison Ps225107ps2307 Mptool Install Link Jun 2026

If the drive is detected, check the box next to your drive's slot. Click .

The definitive tool for repairing and reprogramming USB flash drives utilizing the controller is the Phison MPALL (Mass Production Tool) . When a flash drive exhibits symptoms such as becoming write-protected, displaying "Insert Disk" errors, or dropping to 0 bytes of capacity, it generally indicates that the controller's firmware has corrupted.

Click and do not unplug the drive until the process finishes and returns a green "OK" status.

When a USB flash drive becomes write-protected, shows "No Media" in Disk Management, or fails to be recognized by your computer, it often indicates corrupted firmware. For drives running the Phison PS2251-07 (also known as PS2307) controller chip, the Phison MPTool (Mass Production Tool) is the official utility used to rebuild the file system, flash new firmware, and restore the drive to factory settings. phison ps225107ps2307 mptool install

Select USB 3.0 (or USB 2.0 depending on the target port you are using).

Before attempting to download or install any utilities, you must verify that your USB flash drive actually uses the controller chip. Running tools on mismatched hardware can result in a permanent hard-brick.

Before attempting a repair, you must identify the exact hardware specifications using a tool like or Flash Drive Information Extractor . Reflashing with the wrong firmware can permanently brick your device. Controller Model: Must be confirmed as PS2251-07 or PS2307. NAND Type: Identify the memory chip (e.g., TLC, MLC, eD3). If the drive is detected, check the box

To install and use the Phison Mass Production Tool (MPTool/MPALL) for controllers like the PS2251-07 (PS2307) , follow these steps to reflash or repair your USB drive. 1. Preparation & Identification

: Use this to confirm your controller is indeed PS2251-07 and identify your specific NAND flash type.

Must explicitly state PS2251-07 or PS2307 . When a flash drive exhibits symptoms such as

This usually means the firmware file is incorrect for your specific NAND flash. Double-check your flash type in ChipGenius.

: The core user interface executable for the flashing process.

[PenDriveMP] IC Type=2251-07 Mapping Do Not Care=1 [Parameter Setting] Mapping=1 Host Port=2 Set File=MP.ini [Flash Setting] Flash IC=Auto [Firmware Setting] Firmware Name=C:\PhisonMPTool\FW07V50253TW.BIN Burner Name=C:\PhisonMPTool\BN07V502TAW.BIN Use code with caution.