Weltouch Cy-210b Manual Patched

Release the buttons. The unit is now restored to its original factory settings and will require reprogramming. Preventative Maintenance and Best Practices

The CY-210B uses an LED display system. The front panel consists of:

Open the back compartment. Insert (do not use carbon-zinc). Observe polarity (+/-). If the display shows “Lo” immediately, your batteries are weak or reversed.

: The CY-210B is designed for a horizontal configuration and easily integrates into most existing contactor cabinets.

Connect the other Level One wire to terminal #7 for the start schedule. weltouch cy-210b manual

A: Connect the emergency stop pushbutton to the designated E-stop input terminals on the controller. Use shielded cable for this connection to avoid electrical noise interference.

This article serves as the complete . We will cover everything from initial unboxing and calibration to error codes and maintenance. By the end, you will know this scale better than the factory technicians who assembled it.

Standard resistance welders frequently suffer from line voltage drops during a plant's peak load hours, yielding weak welds. The Weltouch CY-210B overcomes this by applying via an external toroidal coil (CT coil).

The unit supports both single-level and dual-level foot switches. These are connected via a screw-type terminal block on the back of the device. Single-Level Setup: Release the buttons

Elias was a man who believed that if something could be fixed with a hammer, it wasn't truly broken, just stubborn. But the WelTouch CY-210B was testing that philosophy.

Connect to the welding transformer and ground all components. 4. Basic Operation & Scheduling

Given the lack of an accessible manual, many wonder if this is a smart purchase. Compared to newer Bluetooth scales, the CY-210B remains relevant for three reasons:

A: This is called “corner load error.” The manual specifies ±0.03g variance. Always place items in the dead center. The front panel consists of: Open the back compartment

: Adjust the CYCLES display for the Squeeze phase. This provides time for the pneumatic system to reach nominal mechanical force before passing current.

Includes two-stage initiation, pulsation, up/down slope, and preheat/post-heat settings. Setup and Wiring Basics According to the official addendum for the CY-210B

: Secondary constant current feedback control (reconstructs the current waveform via a toroidal coil every half-cycle). Memory Capacity : Stores up to 15 distinct weld schedules .

Those probes are sensitive. If your soil is compacted like concrete, use a screwdriver to pre-drill a pilot hole. Pushing too hard will bend the probes permanently.