With the hardware installed and addressed, the final step is to program its functionality and verify the installation is working correctly.
Right-click on the icon and select Printing Preferences . Go to the Page Setup tab.
: Includes an output that can control a door strike or relay. Environment : It is rated , making it suitable for wet or dusty environments. Ness Corporation Official Documentation & Support Aritech/Tecom Support Portal
:
: "The TS1162 Installation Manual provides a comprehensive guide to setting up the equipment. The document is generally well-organized, but could benefit from clearer visual aids to assist in the understanding of complex installation steps. The technical details seem accurate and up-to-date. However, additional troubleshooting tips and a detailed FAQ section would enhance the manual's value to the end-user. Overall, it serves as a good foundation, with some areas for improvement to make it more user-friendly and comprehensive." ts1162 installation manual
Connect the DC power source (check your specific model for 12V or 24V requirements) to terminals V+ and V-. Always use a grounded power supply.
Turn on the main circuit breaker to restore power to the circuit.
Turn off the printer and allow the printhead to cool down for 2 minutes. Open the top cover and the ribbon mechanism chassis.
Complete TS1162 Installation Manual and Technical Guide The Aritech TS1162 Remote Arming Station (RAS) Keypad With the hardware installed and addressed, the final
This guide provides a structured overview of the installation process based on typical Challenger LAN wiring practices and technical specifications. 1. Introduction to the TS1162 3 LED RAS The Tecom TS1162
: Displays the current state of the printer (Ready, Error, Media Out).
If you are looking for specific configuration steps, the following details are essential for the TS1162: Wiring & Connection
Lift upward to disengage the top hinge hooks and separate the front keypad housing from the mounting base. Step 2: Prepare and Mount the Base Plate : Includes an output that can control a door strike or relay
For environments where the keypad face may become worn, a replacement TS1162-LABEL (membrane) is available to restore the unit's appearance and button legibility.
Connect the wiring (see below) and snap the keypad onto the backplate. 3.2 Wiring the to Challenger LAN connects to the Challenger LAN via four main terminals: +12V: Positive power supply from Challenger LAN. 0V: Ground connection. D+ (Data+): LAN data line. D- (Data-): LAN data line.
Open the ribbon mechanism chassis by lifting the green ribbon access lever.