Ultimate Guide and Operating Manual for the Disco 240 DMX Controller

The Disco 240 is a standard 19-inch rack-mountable DMX controller capable of managing up to [1]. It allows for the simultaneous control of up to 12 intelligent lights (fixtures) , each with up to 20 channels [1]. Key Features:

The Disco 240 features a standard 3-pin XLR output (both male and female connectors are usually present for daisy-chaining).

Set your fixtures to the correct starting address. Generally, Fixture 1 should be A001cap A 001 , Fixture 2 should be A021cap A 021 channels), and so on. 4. Programming Guide: Creating Your Show allows you to create custom scenes and chases. A. Recording a Scene Press Program for 3 seconds until the indicator flashes. Select the Scanner/Fixture (e.g., button 1). Use the Faders to set the desired colors and positions. Press the MIDI/Add button. Select a Bank ( ) and a Scene button ( ) to save. B. Creating a Chase (Automatic Movement) Enter Program mode. Select a Chase button ( Select a Bank that contains the scenes you want to use. Press Scene Button 1 , then MIDI/Add .

If your moving heads are moving in the opposite direction of your fader pull, check your fixture's internal menu to see if you can invert the Pan or Tilt attributes locally.

Move the fader to set how long the scene stays on screen (Step Time). Move the CROSS fader to set how long it takes to fade from the previous scene to the new one (Cross Time).

Press one of the buttons. The LCD screen will show the chase number you are about to program (e.g., "CHASE: 01").

Note: If your lighting fixture only uses 4, 6, or 15 channels, it will still occupy all 20 channel slots allocated to that button. The remaining channels up to the next start address will simply be left unused. 3. Programming Static Scenes

Mistakes happen. The Disco 240 allows you to clear individual scenes, entire banks, or reset the unit completely. Deleting a Single Scene Enter . Navigate to the target Bank using the Bank Up/Down buttons.

For troubleshooting specific fixture compatibility or more advanced chases, the DMX512 protocol is universal—the principles of addressing and signal management applied here will serve you for your entire lighting career.

are you connecting to the controller?

The board features 12 physical sliders. Because the controller supports up to 20 channels per fixture, the Page Select button switches between Page A (Channels 1–12) and Page B (Channels 13–20).

Create a scene using your fixtures and channel faders, or select an already-saved scene from an existing bank.

[Select Chase 1-12] │ ├─► Manual Mode ──► Use Speed/Fade Sliders manually ├─► Auto Mode ────► Console cycles steps based on internal clock └─► Music Mode ───► Internal microphone triggers steps on bass beats Manual Triggering

Press the Page Select button to toggle the faders to control channels 9 through 16. Control Faders (Speed and Fade Time)