Staples 17466 Laminator Manual & Troubleshooting Guide: Comprehensive Guide
Feed the sealed end of the pouch into the entry slot first. Do not force it; the rollers will grab and pull it through automatically.
: Plug the unit into a grounded outlet. Switch the power button (typically located at the rear) to the ON position. Select Setting :
With a warm-up in 3-5 minutes, your laminating tasks will be fast and efficient. Staples.com Laminating Pouches Letter Size staples 17466 laminator manual
Up to 9.5 inches (Accommodates Letter, Legal, and A4 sizes) Heating System: Dual roller system Temperature Modes: Thermal (Hot) and Cold Pouch Compatibility: 3 mil and 5 mil thicknesses Warm-up Time: Approximately 3 to 5 minutes Anti-Jam Feature: Manual jam release lever Important Safety Precautions
Keep the pouch straight and centered. Guide it gently until the motorized rollers catch the plastic and begin pulling it automatically.
: If you are doing both hot and cold lamination, do the cold setting first to avoid waiting for the machine to cool down. 4. Troubleshooting & Maintenance Switch the power button (typically located at the
The laminator is not hot enough, or the pouch is too thick for the setting.
Wait an extra 2–3 minutes after the green light turns on before feeding your next pouch. Ensure your setting matches your pouch thickness. If it is already cloudy, try running the document through a second time to clear the haze. The Pouch Comes Out Wavy or Rippled
Wipe the exterior plastic housing with a dry microfiber cloth only after the machine is unplugged and fully cool. What (3-mil or 5-mil) are you using? Is the Ready light turning on successfully? Guide it gently until the motorized rollers catch
Allow the pouch to pass through completely before removing it. Cold Lamination Set to Cold: Switch to the "Cold" position.
Seconds felt like hours. Finally, the card emerged from the rear exit, transformed. What was once flimsy, stained paper was now a rigid, glossy artifact, impervious to future gravy spills.
Plug the laminator into a wall outlet and turn on the power switch (usually located on the rear right side of the machine).