: Start or stop the generator manually using the START and STOP buttons.
: Allows operators to start or stop the engine directly using the Start and Stop keys on the front panel.
for PC connection, allowing for remote troubleshooting and status monitoring. User Interface:
Here are the standout technical specifications and key features: lovato 31 rgam 12 user manual
: It monitors three-phase mains voltage and single-phase generator voltage and frequency. It also tracks battery voltage, engine speed (RPM), oil pressure, temperature, and fuel levels.
Can be networked to manage up to 32 units under a single central control.
(Generator) keys to manually switch the load between sources. AUTOMATIC (AUT) : Start or stop the generator manually using
| Issue | Likely Cause & Fix | | :--- | :--- | | | Magnetic brake is programmed but not installed. Use keypad programming to disable this output. | | A-15 Alarm active after service | The internal service counter requires resetting via the PC-RGAM software suite. | | Can't enter parameter setup | Verify you are using the correct command sequence for your specific unit (clone vs. genuine). | | Load won't transfer to generator in AUT | Confirm the Mains Absence delay has elapsed and the unit has moved through the engine start cycle. |
Forces the generator to fire up under simulated emergency conditions. Depending on how parameters are configured, it can test engine readiness with or without transferring the actual building load. Comprehensive Wiring & Input/Output Mapping
If using a modem, check that the "Autocall" function is configured correctly for SMS/Email alerts. 6. Where to Find the Complete Manual (Generator) keys to manually switch the load between sources
Features 12 independent relay outputs to control up to 12 capacitor steps. Mechanical and Environmental Data
Unlike a simple light switch, the RGAM 12 requires configuration for your specific application. Do you want a delayed transfer? Do you need a cool-down timer for the generator? The manual holds the key to these settings.