Redsail Cutting Plotter Software Installation Instant

Install the software and select "Redsail" or "Redsail HP-GL" from the device list.

Or the downloaded driver files from the official Redsail site.

If the cutter does not work, ensure the COM port in the software matches the Device Manager exactly, and verify that the baud rate is 9600. 5. Troubleshooting Common Installation Issues

Once installed, check the Ports (COM & LPT) section. Note the port number (e.g., COM3 ). You will need this later. 3. Step 2: Software Installation (Artcut Example) redsail cutting plotter software installation

Even with careful setup, issues can arise. Here are the most common problems and their solutions.

Run the installer, which automatically detects your active CorelDRAW version directory.

This is the creative command center of your setup. It's the program you use to design graphics, set cutting parameters (speed, force), and send the final commands to the plotter. Redsail plotters are compatible with a wide range of design and cutting software. This flexibility is one of their greatest strengths. Common compatible software includes: Install the software and select "Redsail" or "Redsail

Write down the COM port number (e.g., COM3). You’ll need it later in your cutting software.

Even with perfect steps, issues arise. Here are the solutions to the top 5 RedSail installation problems.

: Place a small piece of vinyl or paper into the plotter and lock the pinch rollers. You will need this later

: Uninstall the USB driver from Device Manager, restart the PC, and reinstall the driver.

What (ArtCut, CorelDRAW, SignMaster, etc.) do you plan to use? Do you have the original driver installation disc or files ? Share public link

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Draw a simple 2-inch square or circle in your software. Click send to cut.

Click the new Redsail icon. In the pop-up menu, configure the output port to the matching COM port discovered in your Device Manager settings. Step 4: Testing Your First Cut