To keep your Autocraft AC-60CR working for years:
Controls the charging duration and manual or timed modes. 3. Pre-Charging Instructions
Always turn off the charger switches before connecting or disconnecting the clamps to prevent accidental sparking. Control Panel Features and Settings
| Issue | Possible Causes | Solutions | | :--- | :--- | :--- | | | - No power at the outlet - Damaged power cord - Internal breaker tripped | - Check that the outlet is live (test with another device) - Inspect the cord for damage; replace if necessary - Check for a tripped breaker; some chargers have a reset button | | Charger hums but no charge | - Poor connection to battery - Battery is deeply discharged or faulty - Internal diode or transformer issue | - Ensure cables are securely attached to clean terminals - Test the battery; it may need replacement - Internal issue likely requires professional service | | Charger cycles on/off | - Loose AC or DC connection - Overheating protection activating - Internal fault | - Check all connections are tight - Move charger to a cooler environment - Contact a professional if problem persists | | Yellow flashing light | - Reverse polarity - Thermal sensor issue - Battery voltage too low | - Check and correct cable polarity (red to +, black to -) - Allow charger to cool down if overheated - Check battery voltage; may need a boost first | autocraft battery charger ac-60cr manual
The Autocraft AC-60CR is a battery charger that has appeared in the inventories of various automotive and industrial equipment auctions, often as part of shop closures or equipment liquidations. It is designed for charging automotive batteries, a task that requires careful handling of electrical components to ensure both personal safety and the longevity of the battery.
The 200-amp engine start function can crank an engine with a severely discharged battery.
Ideal for small AGM/Gel batteries or long-term maintenance of motorcycle and lawnmower batteries. To keep your Autocraft AC-60CR working for years:
Wrap the AC power cord and heavy jumper leads around the built-in handle hooks to prevent tripping hazards and cord fraying.
The Autocraft AC-60CR is a 12V lead-acid battery charger and maintainer designed for automotive and small marine batteries. It provides charge, float/maintenance, and sometimes a low-current conditioning mode for sulfated batteries. (Assume a single 12V battery unless your unit explicitly supports 6V or other modes.)
Always wear complete eye protection and protective clothing when working near lead-acid batteries. Control Panel Features and Settings | Issue |
Locate the charger as far away from the battery as the DC cables permit. Never place the charger directly above or below the battery being charged.
Turn off immediately. Check that red is on positive and black is on ground. Overcharging or incorrect voltage setting
: Used for faster charging of depleted batteries.