The V2000-C is factory-calibrated. Re-calibrate only if the device warns you (every 6 months).
NC (Normally Closed) – Used for standard electric locks.
is a popular, standalone RFID access control keypad often used for securing office doors, residential gates, and restricted storage areas. This blog post breaks down the essential steps from the V2000-C user manual to help you get your system up and running.
You will hear two short beeps, and the LED status indicator will turn yellow. v2000-c user manual
for high-resolution wiring schematics if the printed manual is unclear. 3. Essential Programming Commands Once powered on, the device requires setup. You must enter Programming Mode using your master code (the default is often
Before mounting the hardware, installers must verify that the incoming power source matches the device's operational range of . Power down the main circuit breaker before touching any bare copper conductors to avoid frying the internal electronic board. Common Keypad Wiring Connections
If you lose your custom Master Code, you can reset the device without wiping the enrolled user data. Disconnect the main power supply from the unit. Press and hold down the # key on the keypad. Reconnect the power while keeping the # key held down. The V2000-C is factory-calibrated
: Enter programming mode, swipe the new RFID card, and the unit will beep to confirm. Changing the Master Code
: Use a drill and the included screws to secure the RFID panel to a wall near a stable power outlet and, if applicable, your network port. 2. Wiring for Success
Flash the OR input the known [4-Digit User ID] associated with the profile. is a popular, standalone RFID access control keypad
The system issues a short confirmation beep; the new code replaces the default. 3. Setting Access Control Modes
The serves as the definitive reference guide for deploying, configuring, and maintaining the popular V2000-C Standalone RFID Access Control Keypad Go to product viewer dialog for this item.
: Wire directly to the negative terminal of your power supply.
Ensure there is at least 3 inches of clearance for ventilation and wiring. Basic Wiring Diagram Connect the DC power supply to the designated +/−positive / minus terminals.