Firstchip Fc1178 Fc1179 Mptools V1052 Link !!link!! Jun 2026

Optional Language Change: If the initial interface loads in Chinese, navigate to the upper-right corner drop-down menu and switch the display setting to . 3. Execute the Low-Level Format

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Firmware Reflashing: Reinstalls the controller software to fix "Unknown Device" errors.

:

⭐⭐⭐☆☆ (3/5) – Functional but dated. Use v106_2 or v108_0 for better FC1179 support unless you specifically need v1052 for an older FC1178 drive. If you’re trying to fix a generic “Kingston” or “Sony” fake USB, this tool is worth a shot – just proceed carefully. firstchip fc1178 fc1179 mptools v1052 link

Configuration: Click on the "Settings" button. If it asks for a password, usually leaving it blank or entering "123456" works. Here, you can choose "Product Mode" for a standard repair or "Test Mode" for deep diagnostics.

Launch the diagnostic app and check the and Controller Part Number lines.

The interface is mostly in Chinese. On the right side, there is a Language dropdown. Change it to English if available, though sometimes it works best in Chinese.

: An older, highly versatile controller variant handling multiple older MLC and TLC NAND flash configurations. Optional Language Change: If the initial interface loads

If the default setting fails, you may need to adjust the configuration. Click the "Setting" button in the application.

Flashing low-level firmware deletes all existing data partitions permanently.

If you run into any specific error codes during the flashing process, tell me the or the NAND Flash ID shown in ChipGenius so we can adjust the configuration settings! FirstChip FC1179 MpTools V1.0.7.2 (2024-02-21) - USBDev.ru

The official FirstChip website offers some downloads: This link or copies made by others cannot be deleted

What error message are you seeing, or is the drive not showing up at all? Share public link

If your drive shows 0 bytes, RAW, or “Insert Disk”, it’s already in MP mode.

Shorting Pins: In extreme cases where the drive is "bricked" and not detected at all, you may need to manually short the pins on the NAND flash chip to force it into "Mask ROM" mode. Download Link Information