Xh-m608 Manual Jun 2026

Relay closes when voltage drops below P1 (starts charging) and opens when voltage reaches P2 (stops charging).

[ Battery + ] -------------> [ Vin + ] [ Vout + ] --------> [ Load + ] [ Battery - ] -------------> [ Vin - ] [ Vout - ] --------> [ Load - ]

What is the of your system (12V, 24V, 36V, 48V)? Xh-m608 Manual

If you are currently setting up your module,g., Lead-Acid, Li-ion, LiFePO4) and your . I can give you the exact values to program. Share public link

Connects to COM when the relay is triggered (e.g., charging is active). Relay closes when voltage drops below P1 (starts

Behavior: The module allows the load to run continuously until the battery voltage falls to your low cutoff limit, instantly breaking the circuit to isolate and save the cells. The Master Function Matrix (P0 – P3 Settings)

Always test the controller with a low-power load first, use an external fuse, and refer to online tutorials to fill the gaps left by the original manual. I can give you the exact values to program

In this setup, you connect your battery to the input and your load (like a motor or lights) to the output.

A: Press and hold both the + and - buttons simultaneously until the display shows "888".

Connect the of your load directly to the battery's negative terminal.

When operating under , long-pressing the DEC button from the main screen displays the remaining active countdown timer. 4. Performing a Factory Hard Reset