Renault Kangoo Ze Service Reset Top Jun 2026

: Use the buttons on the end of the wiper stalk (up or down arrows) to scroll through the trip computer options.

: Release the button and turn the ignition off. Turn it back on to verify the "Service Required" or spanner light has disappeared. Important Notes

This is the official “button dance” used by Renault technicians when they forget their CLIP diagnostic laptop.

Use the on the right side of the steering wheel to find the service interval display. renault kangoo ze service reset top

If Method 1 fails, your Kangoo ZE might require a combination of wiper stalk and brake pedal.

From 2016 facelift, some Kangoo Z.E. models include a basic steering wheel menu control.

Use the up/down buttons on the steering wheel stalk to toggle through the menu until you see the "Service Required," "Service Due," or the mileage to the next service screen. : Use the buttons on the end of

Once the service target or mileage limit is blinking or highlighted on your screen, . Keep holding the button for 10 to 15 seconds . The display will begin to flash rapidly. Do not let go of the button while it flashes. Step 6: Confirm the Reset

Once the service interval screen is displayed, press and the upper button on the wiper stalk tip. Keep holding the button down firmly. 6. Wait for the Display to Flash

After holding the button for approximately 5 to 10 seconds, the display will begin to flash. Keep holding the button. The display will then show the new reset interval (typically 12,000 miles, 20,000 km, or 12/24 months depending on your local region and vehicle generation). 7. Confirm the Reset Important Notes This is the official “button dance”

The service reset process for the Renault Kangoo ZE is relatively straightforward. Here's a step-by-step guide:

While resetting the service light is a simple task you can perform at home, certain situations require professional Renault EV servicing:

On newer Kangoo Z.E. phases, once you land on "Service Intervals", press and hold either the Up or Down stalk button for approximately 5 seconds until the display changes to show the specific mileage and month breakdown (e.g., "Service in 12,000 miles / 12 months"). Step 5: Perform the Reset Flash