Ikegami Bsf-300 Manual Now
The primary cause of CCU failure is dirty fiber connectors. Always keep dust caps on when cables are disconnected. Clean connectors every time they are plugged in.
Lightweight and compact design (1.5U, 19-inch rack mountable). Compatibility: Designed for Ikegami HDK-73 cameras. 2. Technical Specifications & Features
There are two main models of the BSF-300, distinguished by their fiber connector type:
Turn on the BSF-300. Observe the front panel LEDs. The CAM POWER light should stabilize, indicating successful handshake and power delivery to the camera. 4. Technical Specifications Specification Form Factor 1.5U Rackmount Power Requirements AC 100V to 240V, 50/60Hz Operating Temperature -10°C to +45°C (14°F to 113°F) Supported Video Output 1080/59.94i, 1080/50i, 720/59.94p, 720/50p Transmission Distance Up to 2,000m (using SMPTE Hybrid Fiber Cable) Genlock Input Tri-level Sync or Black Burst (0.3Vp-p) 5. Maintenance and Troubleshooting Cleaning Optical Connectors
If you are currently setting up the BSF-300 and need specific advice, please provide: ikegami bsf-300 manual
Confirms stable data transmission between the base station and the camera optical fiber adaptor. Rear Panel Connectors
is a high-performance, compact base station designed to provide reliable, uncompressed, high-quality picture transmission for broadcast and production environments. It is a critical component in Ikegami’s HD camera systems, enabling seamless fiber transmission for HDK series cameras over shorter distances.
The BSF-300 is engineered to support Ikegami’s high-definition camera series (such as the HDK series). It processes high-quality video signals, provides power to the camera head, and facilitates seamless communication between the operator and the control room. Technical Highlights
Secure the BSF-300 in a well-ventilated 19-inch equipment rack. Leave adequate space above and below for cooling fans. The primary cause of CCU failure is dirty fiber connectors
If you are performing maintenance on the BFS-300, you may encounter these trim-potentiometers (pots):
Connect a house reference signal (Tri-level sync or Black Burst) to the Genlock Input. Terminate the loop-through if not daisy-chained.
These allow you to change which signal appears on physical BNC output 1. For example, you can turn Output 1 from Black Burst to a continuous sine wave subcarrier. The manual provides a truth table for this mapping.
Uses a LEMO SMPTE connector, enabling remote powering of the camera head. Lightweight and compact design (1
The rear panel handles all signal routing, control interfaces, and power inputs. SMPTE-304M hybrid fiber optic connector.
Ensure the AC voltage source matches the unit's requirements before plugging in the power cord. Keep the main power switch off during initial cabling.
The Ikegami BSF-300 is a highly reliable base station designed for professional broadcast and studio applications. It acts as the critical bridge between Ikegami fiber camera heads (such as the HDK series) and the control room production switcher. Navigating its technical documentation can be challenging due to its complex engineering.
1080i (50/60Hz), 720p (50/60Hz), 1080PsF (25Hz), and SDTV (625i/575i). 3. Installation and Setup (From the Manual)